Beefsteak
It may seem needless to direct one how to carve a sirloin steak, but it sometimes appears to require more skill than to carve poultry, as those who have been so unfortunate as to receive only the flank can testify.
I believe most strongly, as a matter of economy, in removing the bone, and any tough membrane or gristle that will not be eaten, before cooking the steak. If there be a large portion of the flank, cook that in some other way. With a small, sharp knife cut close to the rib on each side, round the backbone, and remove the tough white membrane on the edge of the tenderloin. Leave the fat on the upper edge, and the kidney fat also, or a part of it, if it be very thick. There need be no waste or escape of juices if the cutting be done quickly, neatly, and just before cooking. Press the tenderloin—that is, the small portion on the under side of the bone—close to the upper part, that the shape may not be changed.
In serving place it on the dish with the tenderloin next to the carver. Cut in long narrow strips from the fat edge down through the tenderloin. Give each person a bit of tenderloin, upper part, and fat. If the bone be not removed before cooking, remove the tenderloin first by cutting close to the bone, and divide it into narrow pieces; then remove the meat from the upper side of the bone and cut in the same manner. A long, narrow strip about as wide as the steak is thick is much more easily managed on one’s plate than a square piece. Serve small portions, and then, if more be desired, help again.
In carving large rump steaks or round steaks, cut always across the grain, in narrow strips. Carving-knives are always sharper than table-knives, and should do the work of cutting the fibres of the meat; then the short fibres may easily be separated by one’s own knife. There is a choice in the several muscles of a large rump steak, and it is quite an art to serve it equally.